BX-25 Hot Hyd.oil

[snowman1]

Will uping the Hyd.pressure cause the Hyd oil to get hotter then normal

 

[Bulldog]

I would think that a increase in pressure would also mean a increase in heat.

 

[Grouse Feathers]

Why do you ask? From the title of the post is your hydraulic oil hot? If so have you checked the cooling fan?

 

[snowman1]

Yes I have , The fan is OK. I was using the loader the other day fixing washouts and when I was removing the loader ,The quick connects burnt my fingers. I never noticed them that hot before. I increased the Pressure from 1750 to 2000psi.

 

[koja]

Its normal . You should try touching the cylinders on case 590 super e after using it hard for e few hours .

 

[North Idaho Wolfman]

Yes bumping the pressure up will increase heat.

 

[Hondahead]

I have bought the shims to increase my hydraulic pressure. I just ordered one of each size shim available. Even thought I am probably just going to add .2 shim. Do you know why only the .2 shim has a hole drill through? Whereas the .1 shim and .4 shim are solid? Sorry if that is a silly question. I have not being through the manual fully or had the pressure relief valve apart to understand it yet.


Sent from my iPad using Tapatalk

 

[Humblebub]

The instructions that accompanied mine (from BXpanded) indicated the hole was there to make it easier to use a small pick to remove the shim.

 

[redfernclan]

The instructions that accompanied mine (from BXpanded) indicated the hole was there to make it easier to use a small pick to remove the shim.

Yep, they fit in the bottom of a hole and would be a bugger to take out without a pick.

 

[snowman1]

Thanks guys,