Manually moving lift arms. At first I thought something was broken or disconnected but after looking at the wsm it appears the piston and connecting rod aren’t connected and this is ok??
Last edited:
B8200 video, is this right?
- Thread starter Codyrapoza
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
No video... 
But yes you can manually lift the arms, and no the rock shaft connecting rod is not attached to the piston.
This allows the three point to float.
But yes you can manually lift the arms, and no the rock shaft connecting rod is not attached to the piston.
This allows the three point to float.
Awesome! I was about to break into there! Can I rebuild the 3 ph lowering control knob without taking the cylinder head off? It seams there is an internal c clip but I’m sure it’s just to keep the valve positioned.