Hello I'm new here I'm also a new tractor owner. Please forgive me if I don't know all the correct terminology. So I have a used B7200 standard trans I believe not the HST. I bought it with a loader already on it and it operated okay but seemed like the valve control probably needed some work. Anyway I sprung a leak on one of the hoses on the loader. At this time I really have no use for the loader so I removed it from the tractor. I need help with where the hydraulic lines go after removal. I have a distribution block where there is a valve and the block is inline with 2 ports. I'm assuming this is where the power is tapped from for the loader.
So I have 2 lines coming from this block to the Valve that controls the loader and a third line that goes from the valve to the fluid fill opening under the seat. The loader is model B1630 FYI. So, what I did was flip the valve 90 degrees, because now there is no loader. The return hose from the oil fill opening I hooked the "out" going port on the distribution block. And I capped the second port on the block. So in the end my 3PH doesn't work since I did this. Can anyone help me?
So I have 2 lines coming from this block to the Valve that controls the loader and a third line that goes from the valve to the fluid fill opening under the seat. The loader is model B1630 FYI. So, what I did was flip the valve 90 degrees, because now there is no loader. The return hose from the oil fill opening I hooked the "out" going port on the distribution block. And I capped the second port on the block. So in the end my 3PH doesn't work since I did this. Can anyone help me?