whenever I raise my hydraulics if i'm not extremely careful and stop before they reach the top then they get stuck and I can't lower them until I wait a couple of minutes and let them leak down. then they work fine until I raise them all the way up again. has anyone else experienced this.
was wondering if there's a way to adjust them so they won't go quite as high and hopefully that will solve the problem. it's a real pain when working the blade in snow or anything where you need to move it up and down.
thanks
was wondering if there's a way to adjust them so they won't go quite as high and hopefully that will solve the problem. it's a real pain when working the blade in snow or anything where you need to move it up and down.
thanks