Looks like we both need the same casing part. Mine cracked when overheated and over pressured - case and cap!
The parts look the same as the B8200 and if so are available in UK - They have to come from Japan and Germany and cost about£1000 for both - I’m hoping for a used part!
Hi Tim
I hope you found your spare part. I eventually bought a full B8200 for scrap and took the 3PL off it.
Base fit is same as you said so it should work.
The B8200 has an oil pressure adjustment screw on the hydraulic cylinder cover. I am wondering if I should change the cover for the original B1600 one which does not have the adjustment. No idea why this adjustment is fitted here??
Also, there is some sort of feedback control, via a rod, from the lift are to the hyd system on the B8200. I hope to be able to avoid having to use that as it would take the place of the B1600 control levers that I hope to reuse (they fit the same outlet plate in the main casting).
Finally there is some sort of strike plate attached to the rear of the well of the main tractor housing which I think limits the travel of one of the 3PL lever parts. This has a slightly different part No in the B1600 vs the B8200 lists and I am wondering if that is significant. (only last digit is different).
I would be grateful if someone can comment on any of above