Recently purchased an 1878 hours B7300 with backhoe, loader etc. Front seal leaking like a sieve at the sprial bevel pinion shaft into differential. Drained the front axle case and it looked like nestle chocolate milk, damn. Filled up UDT and the leak became apparent. Read a post on tightening the pivot bolt, will take a look but assume the seals are as beat up as the bucket. References to good sources / manuals / youtube videos greatly appreciated thank you
Advice on front axle leak for B7300
- Thread starter KGBentz
- Start date
Russell King
Well-known member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
Try Kubota books dot com. They are usually under the tractor operator‘s manual section.
If yours is not there perhaps look at something similar and see how they do it
If yours is not there perhaps look at something similar and see how they do it
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
I've never found a cheap or free WSM for the B7300.
You can get one from a dealer, or here.
You can get one from a dealer, or here.