Pcola Member Equipment B2601 Jul 4, 2015 32 0 6 Cantonment Florida Aug 8, 2015 #1 Hey I have a 2601 and I am trying to hook up my king kutter rotary tiller. Looks like the shaft is 1/2 inch to an inch too long. Should I cut more thanks. Last edited: Aug 8, 2015
Hey I have a 2601 and I am trying to hook up my king kutter rotary tiller. Looks like the shaft is 1/2 inch to an inch too long. Should I cut more thanks.
Bulldog Well-known member Equipment M 9000 DTC, L 3000 DT Mar 30, 2010 5,440 73 48 Rocky Face, Georgia Aug 8, 2015 #2 By shady I guess you mean shaft. Just make sure it has enough slack that it can't bottom out in any position, upper or lower and you should be fine.
By shady I guess you mean shaft. Just make sure it has enough slack that it can't bottom out in any position, upper or lower and you should be fine.
Pcola Member Equipment B2601 Jul 4, 2015 32 0 6 Cantonment Florida Aug 8, 2015 #3 Yes stupid autocorrect. Shaft
D Diydave New member Equipment L2202 tractor, L185f tractor Oct 31, 2013 1,635 8 0 Gambrills, MD USA Aug 8, 2015 #4 Just be sure to cut the same amount, off each half of the shaft...
Pcola Member Equipment B2601 Jul 4, 2015 32 0 6 Cantonment Florida Aug 8, 2015 #5 thinking about cutting 3 inches then hook up and see can always cut more. Any thoughts thanks.
Kennyd4110 Well-known member Vendor Member Sep 7, 2013 1,181 350 83 Westminster, MD www.boltonhooks.com Aug 8, 2015 #6 Please measure carefully, this is not a place to guess-damage to your tractor and/or your tiller could result. Watch this video: https://youtu.be/0vBFJcvs5SE
Please measure carefully, this is not a place to guess-damage to your tractor and/or your tiller could result. Watch this video: https://youtu.be/0vBFJcvs5SE