Search results

Currently there is a small hose about the size of a garden hose that connects the block with the radiator. I would like to maintain this hose on the radiator as well as install the heater within the same port. There is not quite enough clearance to install a T pipe fitting. I was considering...

Can someone with a loader on their b8200 please provide some details of how the hydraulics are connected to the hydraulic system? I am wanting to tap into the hydraulics to hook up a plow and am not sure exactly how to do so. I am thinking that I can connect via the hydraulic block near the...

When I push in the clutch and have the PTO engaged, as the PTO slows down I can here a clicking noise (the noise is somewhat like the noise from the rear wheels of the cement trucks). The clicking stops once the PTO stops. If i simulate the same action as above, but when I push in the clutch i...

It was in running condition when removed from the tractor. the head was bad. Let me know what you are interested in and I can provide photographs of the particular item.

I have a high pitched intermittent noise that occurs when I am at about 2700 RPM's and in eighth gear (Low of High Low Option). The best I can tell it is coming from the gears in the transmission. Are there any gears or shafts that turn quicker when in a higher gear? Will I be able to pear...

How do I remove the shaft and its related assembly from the block? I was able to remove the gear. this is the drive assembly for the hydraulic pump. I am replacing engines and need to use this assembly in the new engine. Please see photographs below:

Located in Central Illinois. Please review springfield, il craigslist for photographs.

I am planning to replace the oil seal (15841-04140) on the front of the engine of my D950. a couple of questions: Can I replace the oil seal WITHOUT removing the gear case? What is involved to remove the PULLEY FAN DRIVE (15752-74280)? Any details would be appreciated (i searched the...

This is a Kubota Grill, Not sure what model it fits. It is for sale.

Could someone please provide details of interchangability of cylinder Heads? Below is a partial list of three cylinder engines. D650 D750 D850 D950 series D722 D782 D1302 L275 D1802 L2402 L2002 one thread within the site mentioned that the D750 and D950 were compatible except the D950...

These are the issues with the engine: Push rods on number one and number three cylinder are slightly bent. Excessive smoke at all rpm levels, with the engine warm or cold. Oil in the radiator, but no coolant in the oil. Black gunk leaking out of the number one cylinder exhaust valve when the...

I have a D950 Kubota Engine that i am considering rebuilding. I would like to install new linears as part of the process. Are the replacement sleeves the proper size to recieve a piston or will I have to have them machined once pressed into the block? I am trying to avoid having to remove the...