Search results

Don’t know what happened there with the pictures. Bob

Well that solves that mystery. Under the drivers side fender there are two connectors (pict below), under the passenger fender there’s a wire that has been torn off. The fenders have two holes toward the back(picture below). I’ll have to find some lights to go on there.

When I turn the hazard switch on both arrows flash on the dash. When I turn the light switch on the tail lights come on. When I use the turn signals the dash lights will flash. I’ve been looking on internet and it could be the relay. I was looking at other L3710’s online and they have lights...

I have a new to me L3710 that the hazard lights don’t work on. I can turn them on and the dash lights flash, but the back light don’t. I checked the bulbs and they work. I can turn in the headlights and they back lights come on. I’m looking for ideas of where I should start looking. Bob

When I worked on a far in MT feeding cows during the winter. We fed with a JD at -40, did it every year for 10 years.

I’m going to be putting up a shop sometime this year. I’ve been looking at steel buildings, but I noticed that a lot of them use 14 gauge tubing for the frame. My question is the 14 gauge frame sufficient for the structure? Bob

I work part time (seeding/harvest for a local farmer. He they raise mainly soft white wheat, price that day was right at $6. He said none of the local dealers can understand why the price is so low since world wheat supply is very low. Bob

All the info I can find on the L3710 GST is that it has an independent PTO. Bob

That’s exactly why I asked. I guess I don’t need to buy one then Thanks, Bob

I read in the forum that Kubota tractors have a built in over run clutch. Is that true? I have a L3710 GST. Bob

That answers my question. Thanks. Bob

Should have stated the I drained 9 gallons of old oil.

I drained the excess hydraulic oil this morning. Drained out approximately 4 gallons before I could see it in the sight glass. Got to checking how much I drained out, that amount was slightly over 9 gallons. According to the service manual it should hold 10.3 gallons. when I drained it I...

That’s what I’ll be doing tomorrow. Bob

I changed the transmission and filter on my new to me L3710 GST. I miss read the amount 10.3 gallons as 12 gallons. Is it OK to leave it all in there or should I drain out the extra? Bob

When I turn the key to run the “Glow Plug” light comes on for 5-10 seconds. Is there any way to test if the glow plugs are working? it’s been around 30 degrees and I haven’t been using the tractor a lot. I just want to make sure it will start if I need it to move snow. Bob

The tractor sat for about a year it was part of an estate, they had changed all fluids and filters just prior to it sitting. I’m going to change the transmission fluid within the next couple of weeks. The lag time has shortened the more I use it. And as I become more familiar with using the...

Ill have to look today. I prefer the freeze plug type. Bob

Right now the temps are around 30-35. You have to crank the tractor quite a bit to get it started. I have to look if there is a heater on it, haven't seen a cord yet. What kind of heater is normally put on the Kubota? Bob

There’s just three positions: off, run and start. Bob