Search results

Have around 250 hours on the F3990 and noticed at the start of this season my left rear tire tread is getting thin. Swapped the left with the right and now the same place is showing wear on it as well. It runs fine, steer the same. I do drive it about a mile to from on pavement to use weekly...

Good to know I like tint, have had it installed on all cars and trucks, but have yet to do the tractor. Should do it, but getting around to loading up and hauling is my issue. Have the equipment just need the cattle prod on me to get moving :rolleyes:

Don't know for sure, but might be the hydraulic pump. Is a loader attached and does it work as it should? Could put a pressure gauge on the hydraulics to see if they are producing correct pressure

Finally pulled the evaporator out and it does work better now. Pulled more out then I need to with the floor plate and side Lock Dif plate, but go it done. Remove seat, then have to unfasten both plastic covers to get at 2 bolts. There is one bolt on each side. Then remove exterior intake...

Think about a Trike motor cycle. The differential only is turning one tire with least resistance yet it sure is hard to make a turn. The farther the tires are out the more the outer tire needs to over run and the inside tire needs to under run. In 4 wheel tractor, the turning will be more...

Don't agree

Need to look at the manual (can be found online) to see how far the tires can go out. Going further then manufacture list is hard on the steering

Thanks I get hung up borrowing things even though my friends have borrowed from me more then once. Might just be easier. I can rent a 3pt pulverizer but have read its not to good on grass areas, only dirt. Unable to rent a 3pt power rake

Finding specs on power rake at about 15 GPM, and my M9540 at 16.9 GPM. Looking at renting a skid steer rake at using it on the loader. Have a 3rd function lines on the loader. Have two friends with CTL (75hp and 120hp) so can borrow their equipment but if I can do it with my tractor, that is...

Agree, just wondering if there is a Min Max (like 500 to 580) or does it really matter? I'm thinking don't go over 600, and for the most part the tractor keeps it close.

Probably dumb question but does the 540 PTO have a min and max rpm range. Pulling my batwing up and down hills the motor rpms change and therefore so does the PTO

I looked into fixing a M7540 with cab and it was way to much I wanted to tackle. That said yours is much smaller and while would be some work, should be easier Kind of thought Wolfman would come in and advise.

Have to split the tractor to get at the part.

Picked up 80 lb of chicken (40lb legs qtr and 40lb tenders) $64 from local factory Didn't want that much, but good deal and others didn't want to split. Still have plenty of beef for now

I just searched for laws in PA on alcohol and was not able to find the back ground check. Must be real new, but not even found anything close to it. Did this just happen or is this just a one store thing?

Many of the small ones may loose the farm, so he would be in a good position if he can hang on

Were good, and been trying for year to get the wife to thin out the freezers. We have 3 freezers (2 uprite and one chest) and there is just 2 of us. Since were not going anywhere the supplies are going done some. I would like to get to just one for regular use. Keep another around incase...

Don't wash the deck or much else on my mower, just a way to wash grease out of things and cause rust. Use air to clean things off. My 20+ old mower has only had spindle bearings replaced about a year ago. Scrape grass out if it ever builds up Swap blades out about 4 times a year

Have not used him but he does know his stuff about pumps.

If it was mounted vertical it would separate water