Search results

I know it's an old thread, but I have the same issue. Where would I find the presume relief valve asked about above?

Thanks again for your help thus far. I will check the suction lines as you stated. I did have a chance to check the plug under the 3pth top link mounting plate, small black plug with a small channel up one side. The channel was free and it fit snugly into the hole. One thing I did notice, when...

Thank you for the reply. I'll check that vent. Would the small leak at the front bucket cylinder introduce enough airto foam up? That might explain the slow fel response as well, correct?

I have a older b7200 hydro that works well for its age. After running it the last few days to move a bit of snow and putting it in the barn as soon as I turn it off it makes a small gurgling sound and a bit of fluid is expelled from the top of the rear end, directly underneath where the top...

I recently replaced the starter solenoid on my b7200. There are two issues which are probably interrelated. When I turn the key the starter sometimes will engage and start the engine but not disengage so I disconnect the positive wire from it so bit doesn't constantly run. Other times it will...

Sold............

Replaced the key switch, still cranks when not in start position. Have to disconnect the positive wire to the solenoid when it starts so I can use the machine and not burn the starter out. Also occasionally spins starter and not engage. Somethings fishy.

B7200 starter issue On top of the old thread I have (no idiot lights)... I replaced the starter solenoid as it needed it, what a pain that is with the hook for the internal starter arm. Anyway, I hooked it up, now when I turn the key to the start position it turns over, but then when the key...

I know this is an old thread, but was the fuse issue solved? I have EXACTLY the same issue. Can not find a fuse behind the dash, and it appears both online fuses up front are still good

Went searching for a fuse behind the dash, nothing I could see.

Manual diagram shows a 15 amp in line fuse after key switch... where is this located? Behind dash? Assuming I need to disassemble dash to get to it?

Connected the battery positive wire by the solenoid to the red power wire, still nothing. Tested the glow plugs and when key turned counter clockwise I was getting 8 volts I believe, so bit seems they are warming for pre start. There's that fusible link, I'm assuming that's for the option of...

Hello, new to the forum. I am now the proud owner of an '86 B7200 w/1640 FEL and woods 650 backhoe. So psyched to have this machine, it was well taken care of. I've changed all fluids, filters, a few hydro lines, etc. It was always hard starting, the previous/original owner always boosted it. I...