Search results

I had same problem lining up pto shaft on my b2650. I found this tool at a farm auction I also saw this example online.

Thanks everyone for the quick responses. It was the foot pedal. Everything good now

Today while operating my b2650, I stopped in the driveway and the engine suddenly shut down and wouldn’t restart. Battery was fully charged, all electrical worked, tried boosting but still wouldn’t start. I wiggled all levers , seat safety switch, pedals etc etc, but no luck.. I then put it...

My b2650 idles at 1040 rpm

I've been using mine for two years. I've used the following implements regularly with no problems whatsoever: Caroni 63 inch flail mower 60 inch box blade 72 inch front snow blade 60 inch bucket 48 inch forks to lift logs I'm about to try a 7 foot sickle bar mower to trim banks of pond So...

I have a b2650 and when I spoke to the dealer about a front snow blade he recommended a 72 inch so it covered the width of the tractor when angled at 30 degrees. I purchased a HLA quick attach 72 inch. I have a 700 foot gravel driveway. I set the shoes about 3/4 inch below the blade cutter ...

I bought my new Titan 60 inch box blade from my Kubota dealer in July 2015 for $710. As for the tractor with loader, bucket and forks, I did not do financing and got 18% off list.

I have a b2650 and have a Titan 60 inch box blade and a Caroni tm1600( 63 inch ) flail mower. Both were recommended by my dealer. I use both regularly and the tractor handles them very well.

I have a b2650 with a 60 inch box scraper and a la534 loader with a 60 inch bucket. Tractor itself 3 pt hitch to front of loader arm is 134 inches. 3 pt hitch to front end of bucket is 155 inches. rear end of box scraper to front of bucket is 179 inches. The total height top of...

Thanks for the replies. makes sense now.

i have a new 2015 B2650HSD There are two inlets on the engine labelled OIL. One is on the very top and to the rear of the motor it has an orange cap marked OIL. Then on the right side of the motor to the front is an inlet with a grey cap marked oil. Are they both for engine oil?

If you are referring to the B2782A Kubota lists it at 380 lbs

Yes I am also a new operator, and a farmer friend of mine gave me the same advice. Thank you for the advice, I am sure it will help me as I learn.

Thanks everyone for your helpful responses. Here are a couple of pictures

I am a new owner of a b2650 . The manual does not stipulate rpms for different operating conditions. What is the correct operating RPMs for example when using the bucket to move gravel and when operating the Box scraper. Is 2000 RPMs the right range.? Thanks.