Search results

Dave what was wrong with your blower? Tom"s blower has no reduction box on his because he is using it on the rear and hie augers are on right.

Thanks Dave

hello just woundering if you ever figured out why your b2771 only throws snow 15 feet? my son has a bx and a rear mount b2771 and it only throws snow about 15feet. it has the same 1/4 gap or so on the impeller and the throttle is cranked.

Greetings, I also cut the firewood off pallet forks, I measured and welded a 2x2 trailer receiver vertically between the forks and I made a fork T shaped, slide it up into the receiver, pit a pin to hold it there. That way I can cut all the pieces 16 inch and I don't have to bend over to cut...

Greetings Orange1forme, I put the 2 inch pipe on my rear blade, and cut the groove down the center, then I put it over the cutting edge, then I took out the 2 bolts on the cutting edge out, cut a piece of flat bar, weld it to the pipe edge covering the cutting edge bolt holes, then drilled the...

We don't get any pot holes in the 300 feet of driveway, the scarifier will be used mostly for keeping the weeds and grass in line, they seem to have really started to take over the driveway this year. I put the flat bar over the teeth to freshen up gravel after the teeth do their job.

Greetings bearskinner, olekid here, thanks to you and birddogger for all the info. I finally finished a custom scarifier and land plane for our driveways, its 54 inches wide, the scarifier teeth are 11/2 inches long, I can move the shoes down to set them at 3/4 inches long, I think i set them 4...

Greetings, I went to Princess Auto and bought 2 ratchet load binders, replace the 2 ends on each 1 with the ends on the tractor top link and lift rod and what a difference now when adjusting either 1

Greetings, I had that problem with ice chains tearing up garage floor. I went to a gravel pit that had conveyors for moving gravel to different piles and asked if they had any used conveyor belt. They gave 18 inch and 24 inch wide, what ever I wanted for free. I just measured what size I needed...

Greetings bearskinner, put job on hold,corona virus, I live in country and have to go city for metal, not going there for a while until I feel safe, city folks are too wishy washy when it comes PPE and to being considerate of others. When I start I will document it. Thanks, later

Greetings bird dogger, between you and bearskinner I have lots of info and idea what to do, Thanks guys for the help, appreciate it . Later

Thanks bearskinner for the info, my winter project is about to begin. Later

Greetings Bird Dogger, if you would send me some measurements I would appreciate it. The 2 angle pieces going from 1 side to the other are they level with the side pieces or below them a little so as to bite into the gravel?

Thanks for the info

Greetings All, anyone build a land plane for 3PTH, if so could you show plans and measurements with pictures if possible? Thanks later

Thanks Dave

I used the tractor for 2 hours never shut off hauling trailers of hardwood, gently top off rad cap and put the dot on the antifreeze in the hole

I checked the temperature of the coolant with an infrared at the radiator cap hole, the antifreeze was at 160 F. what

Greetings, what size thermostat for a B7510

Thanks for the replies, I will try these suggestions out and let you all know how I made out.