Recent content by UWAdventurer

I have tried the blade forward & backward, and I would try upside down if I thought it would help. LOL Backward is a little better. I will give the PVC a try for sure. Thanks for the verification on the under seat knob, that is what I thought. Thanks everyone.

I made some for my rear blade, didn't seem to help much. God luck, hope they work for you.

I was worried about the key issue when I got my first tractor also. I think it i a honor among fellow owners situation. I don't think about it any more, nothing you can do except keep it locked up in a barn, or install a kill switch as mentioned above. Bottom line, if a thief wants it and...

I will give all those ideas a try. I thought the handle next to the fender adjusted the height of the rear blade, i will try to lock it with the handle under the seat. I thought the handle under the seat was to adjust how fast the 3ph goes up and down. I will check Ebay for chains as a last...

I have a rear scraper blade on my L3400 with R4 loaded tires. This is my first winter with it. Compared to the L2950 with R1's I traded in it is awful. I have locked it into 4 wheel drive and still can't plow the driveway without getting stuck. I have about a 6 foot grade in about 150" and I...

You are correct, it looks like there are metal ears welded into the battery area that will only let a certain length battery be installed. That could be worked around if needed I believe but the battery would have to still fit between the hold down bolts. It looks like it could be wider and...

What is the stock battery size and CCA? What size and CCA can I upgrade to?

It sure looks like it, someone has a good woman taking care of them.

Stopped by my local dealer and purchased the cap they said would fit. It doesn't. I thought the cap they gave me was a little small and commented on it, but they said it was correct. I will be getting the serial number on my tractor and taking it back to get the correct cap. For now I am...

I have found some info on the cap and it appears I am missing a white plastic piece inside the cap. Anyone know if you can just buy this piece or the entire cap has to be replaced? Anyone know the cost for the missing piece or a new cap?

So does anyone else have a vacuum occurring/releasing when they loosen their fuel cap? Mine is very noticeable.

I have noticed when removing my fuel cap on my L3400 I get a vacuum sound. When I take the cap off the rubber insert also stays on the fuel tank opening. Is it not venting properly? I cleaned the cap and reinstalled it, but it still seems to be doing the same thing. Tractor seems to run OK...

Have you tried Hound Dog attachments at Michigan Iron Equipment? They may have something. I was going to purchase from them, however, Wood's does not recommend putting a thumb on my back hoe. Email them, they are very helpful.

If I remember correctly each 55W light should pull about 5 amps, so size wire and fuses accordingly.

I would think a large BX series or smaller L series would work well for you. The 3130 mentioned above or I have the L3400. I had a L2950 I traded for the L3400, it was a great tractor also.