Recent content by Southernfarm

Hi Vic, where? Please provide info. Sent from my Z850 using Tapatalk

Does anyone know if an enclosed cab, made to fit the bx2200 will fit my BX25? Sent from my Z850 using Tapatalk

Be sure to put some threadlocker on it before you put it on. Also use a piece of tape on the one side of a boxed end wrench to hold the nut to get it started. Learned that trick here. Worked like a charm. Sent from my Z850 using Tapatalk

Hmmm, up here in Canada we pay $10 per pint for blackberries. My stomach cringed at the thought of yanking them out. But I know what you mean I had a lot growing wild in NC when I lived there. Sent from my Z850 using Tapatalk

Use them all the time on my BX25. Don't use the adjustable stabilizer much. Easier to put on one fork at a time by hand. Keep the forks to be in line with the lift arms or further out and you will be fine. The BX won't be able to lift anything that is heavy enough to bend anything. Sent...

Looking at this tiller for my BX25. Is it too big for my tractor. My ground is just dirt, not to hard and no stones. Sent from my Z850 using Tapatalk

Help for Paul Short aka Wildfire Hello all, Just watched Paul Shorts last video as of April 30. He was cutting down trees and doing stuff with his BX25D. In the video he talked about how his revenue is down 45% on Youtube and is no longer sustainable. Well, him and his wife were...

Did the kit come with the sticker for the fender? Sent from my Z850 using Tapatalk

What did you pay at Lawsons? Do you have a picture of the levers coming through the fender? Sent from my Z850 using Tapatalk

Just bought a BX42S chipper at auction. It is new and it is a Wallenstein Chinese copy. Not bad, just be sure to rebuild it before using it. Anyway it came with a PTO shaft. There is a bolt in the shear bolt place. The cheap Chinese bolts probably would break before anything else, but I...

Thanks all. Thought I would give the duct tape trick per scdeerslayer mentioned first, before pulling the filter. Low and behold the nut threaded first try. Thanks all. Sent from my Z850 using Tapatalk

So if I tip the front end up I can remove the filter without draining the fluid and only loose about a cup while I put the nut on the linkage with some threadlocker and lock washer? Sent from my Z850 using Tapatalk

Here is the video. https://youtu.be/hTtSPcAEJY8 Sent from my Z850 using Tapatalk

I was thinking of buying one of these. Does it also remove that and the leftover fall leaves, that didn't get picked up in the fall? Sent from my Z850 using Tapatalk

Was noticing how my BX seems a bit slow and watched a short Paul Short video (yep he did do a video in under 3 minutes duration). He showed that there is a bolt on the pedal linkage at the transmission Tha gets loose. Sure enough my nut was missing. So to replace the nut I have to squeeze my...