S

Shoes

New member From Chesterfield, MI USA
Messages
2
Reaction score
0
Points
0
Joined
Last seen

Profile posts Latest activity Postings About

  • S
    Vic, Is it your recommendation that the wise thing to do is replace the hub?
    In the diagram I found on line (B7100HST mine is standard gearbox) it appears that the clamp is separate from the hub, yet on my tractor it is welded to the hub. Can you tell me if it should be separate or has someone welded it.
    Thank you again for sharing your knowledge with us.
    S
    Yes, In fact, it appears what I assume is the spring, is nearly fully compressed. It looks as if it were washers. Based on your response can I add washers to the clamp bolt then retighten. would possibly eliminate the wobble.
    Thanks again!
    S
    I have a Model B219 (serial #1842) loader on my B7100 Kubota. My research indicates that there should be a "float position" when the control lever is pushed past the down position. I assume it should have a detent at that point. In my case there is no detent, the handle just returns to the nuetral position. And the loader does not seem to float.
    However, I have not given it a test in the forward direction, I have only tried it in reverse.
    The control valve appears to be original. Although I have no way of knowing for sure.
    Question is: Am I correct in assuming there should be a detent? Based on the way the instruction reads; "The lever must be returned to the nuetral position manually"

    Any information on this condition would be greatly appreciated.
    Thank You!
  • Loading…
  • Loading…
  • Loading…
Top Bottom