Recent content by nedobs

It is fixed and working great i replace the front steering cylinder and fixed the problem the parts man said that is they only thing they ever had go bad so I took his word and now it all good again. Now I will rebuild the old one for a spare Went very smooth. So if your tractor wanders all over...

i will try that Thanks !!

just to update and try to find the cause set the toe and put new tires on and now it only pulls when the tire is in soft ground but if I just move the wheel back and fort it goes straight making me think its the front cylinder leaking internally or am I nuts? But the wheel can be turned with...

Yes i have to turn to the right is the steering controller the part that sits under the steering wheel its a 2010 year model do they sell a rebuild kit or should I buy a whole new one ??

My power steering turns right slowly will going down the road but not when mowing grass ?? I have to turn the wheel real slow to keep it straight !! any ideas I have checked the tires and pressure but can't figure it out ?? Thanks Bill

BTW I filed the back tires with windshield washer fluid good for -30 and it takes 10 gallon per tire for the 26x12-12 tires leaving from the valve stem up for just air so its twenty gallons for both rear tires i guessed its about 75 pound per tire so total would be 150 pounds total weight!

I Got lucky the first time i used a 18x7.50- 8 on the front and26x12-12 on the back worked great no binding cleared mower deck everything went smooth only had to lower deck one inch and it goes faster could not ask for a better swap could have been bad but the gears must be the same on the 2360...

You went the right way its just too deep!! and to deep to cross diagonal to in fact with that deep of ditch You have to get a bigger tractor or a shallower ditch. Mine would cross it because I have a loader that would help get it across!!

The truth is they are the same rim on the rear and all you have to do is go to a taller 18 inch tire on the front I just done it and it all worked well everything fit i bought new rims and did not have to because I did not know so now I know!!!! Everything works as it should and it does go...

I have a 5 foot yamar tiller on my 1860 and it works great have to go slow in new sod but after that tills up nice with no problems does a fine job !!!

I am disabled and can only get on and off at home where the lift is so I am stuck with driving instead of hauling the bad thing is half of my hours are put on driving down the road but kubota says i can't tow it so i am stuck driving at 8 mph kinda boring LOL!

Has anyone swapped tires and wheels from a bx2360 to a Bx1860 to gain one MPH on the Road I have to drive my 8160 four miles each day to the other farm. Don't know if the bolt pattern is the same ?? But it would save me time and hours if it will work?? Any pros and cons ?? Other than money !!

Is it a hard job to get the drive shaft off to install a new fan for cools hyro pump. I moved it to replace fan belt but seems like this is going to be much harder to get the shaft off ?? Any ideas a stick jumped up and took the fan blades off so i ordered a new one hope it not to complicated ...

My PTO switch Has been a problem several times I don't know why it moves but All i do is pull it back by hand while starting !!!

I am trying to find out the bolt pattern on my bx2360 to see if I can switch to different wheels Want to go from 24 inch to 26 on my bx1860 but can't find the bolt patterns anywhere ???