Recent content by Mister

This is all really good information. Thanks!

I wouldn't mind the shade, and protection from rain. I also plow my property with my MX5800, and I get tired of the roll bar knocking the snow off branches, which then goes right down my neck. That said, it's $525 and I want to make sure it's worth it. Do they work pretty well? Does it reflect...

Very good points. I run ballast in the rear tires, plus often times the backhoe attachment or a plow or grader scraper

Fronts are Good Year. 9.5-16. You typically indicate what tire type you want when you order your tractor

I have AG tires front and rear on my MX5800. I have lifted some heavy loads, up to about the capacity of the front loader, which is about 3,000 lbs I believe. Never had a problem. The tires might bulge a bit, but I haven't had problems. Now I notice the side walls say each tire has a max...

Thanks for all the suggestions, everyone. Sounds like I need to stop using the tarp, and start using mothballs on a sock in various places

This cat roams my property, but he's clearly slacking on the job 😁

It's been a couple weeks since I've used my tractor. Barn is getting built next year, so until then it's got a canvas waterproof tarp over it. I was pretty puzzled when I removed the tarp today, and found all these branches and leaves that some sort of animal had put all over the deck. I...

Update. Got a price for a factory wheel from my Kubota dealer. They said it's $105. I had them order one for me. Thanks again for your help Sent from my SM-N975U1 using Tapatalk

Great Info. Thanks! Sent from my SM-N975U1 using Tapatalk

Thanks for the info. Do your front wheels have an area that would hide the bevel on those lugnuts if you installed them bevel facing in? On my other front wheel, you can't when see the bevel when the lugnuts are facing bevel in. That's how it messed me up when I installed the lugnuts when I got...

Lol. Sounds good. I'll check the machine shop option Sent from my SM-N975U1 using Tapatalk

Another question I just thought of. If I get new studs and lugnuts, and install them properly with the tapered end facing towards the wheel, do you think it'll work? Sent from my SM-N975U1 using Tapatalk

Thanks for the help everybody! Sent from my SM-N975U1 using Tapatalk

I got a flat a while back and when I replaced my wheel, I was stupid and ended up putting the lugnuts on backwards. They have this tapered end that's supposed to go towards the wheel, but I installed them all with the taper facing out. Well... I plowed with the tractor (MX 5800) a lot over the...