Recent content by Lostdutchman

Does a jd model 70 fit an L2850? I can't seem to find Any dimensions on the mount for it. There is one comming Up for auction. If it is anywhere close to fitting I think I I think I will try to pick it up Jason

While bush hogging the other day my L2850 started popping out of Low gear. It is really annoying having to stop and put it back in low. I split the tractor to change the main seal on the tranny last year. I Didn't make any adjustments to any of the gears in side. I did adjust the Clutch. Has...

Is fluid properly serviced? I put too much in mine when I changed the fluid and filters. It got real foamy and the 3 pt was erratic. When I corrected it has worked fine. Sent from my iPhone using Tapatalk

If you want to go fast get a Ferrari :). I would second the filter change if hst. Sent from my iPhone using Tapatalk

I can't seem to get the clutch adjusted on my 2850. In order to get the pto to shut off the throw out bearing is always spinning. When I put the new clutch discs in and pressure plates I couldn't find a way to accurately adjust the bolts that contact the bearing. I Left it where it was when I...

I got lucky today and got it back together. I think it was hanging up in the pilot on the back of the crank. Either way it took a bunch of measurements and wiggling but she is back together. I have a few more panels to put on. Then it's run time. I hope it doesn't leak any more. I took the hyd...

Well I started to put her back together tonight. I haven't had a chance to pull the hyd pump yet. Does anybody have any tricks for getting the shaft back thru the clutches. I tried for three hours tonight. Measuring the gap between the halves. It gets about 3/4 inch from being together then...

They are awesome. Defiantly making memories Sent from my iPhone using Tapatalk

I was thinking pin scraps also but the shape is wrong. The pin sides are rounded and the pieces have 3 flat sides Here is a closer view. As for the source. I think he's about 3 foot tall. I left the fill cap off while I had it split before. His cohort also in the picture might have been an...

The chunks are shaped like a gear tooth. I pulled the top cover off to look at the gear set. All the gears looked good. The srynchros looked fine. I also pulled and split the hyd filter. Found a washer and cotter pin that looked like they went a couple rounds with a gear. Looking at the pictures...

Hopefully nothing. I didn't notice anything when I dropped the fluid before the first split job Sent from my iPhone using Tapatalk

Here is a pic with a standard apex bit Sent from my iPhone using Tapatalk

Just when I thought this would be easy she threw a curveball and nailed me in the noggin. I started to take the l2850 apart again to split for oring replacement. When I drained the hydraulic fluid I found some metal chunks in it. They are pretty large steel parts. It looks like the corners of...

Does it have a bar across the selector? The 2850'does but has to be moved aside for switching speeds Sent from my iPhone using Tapatalk

Where is the leak from Sent from my iPhone using Tapatalk