Recent content by Gwizz

thanks, i was able to get it apart and have the clutch housing removed and setting down on the floor and will be moving it to a bench. i see from the back side the bearing plate that is bolted on holding the various shafts in place ( not the propeller shaft ) without getting up on the bench yet...

thanks, i had seen mention of how to remove the gst valve but it wasnt clear it needed to come out before hand. also it didnt look fun, saw a warning about not droping some pin. here is what i found in the wsm on the gst valve, not much just enough to pucker me up. and removing the clutch...

well i got it apart and from what i can see the leak must be coming from the front propeller shaft looking over the wsm and the online catalog and i dont see how the seals are accessed and from looking at the front of the clutch case i hope they are accessible from the other side so i...

i gave it everything i had but had to bust out the cutting tools and make the hole bigger. came apart without much fan fare after that. i was able to remove the "fender, floor seat and platform assembly" removed and cleaned away all the accumulated dirt and debris. fortunately it didnt seam to...

thanks, i figured why wait for morning so i went and gave it a whack. i didnt have any punches i could reach up from bellow but was able to et on it with a 3 pound slide hammer no action there so i strun a come-along from the rafters and put a good bind on it. tried rapping it on the side with a...

thanks, i guess i will be breaking out the hammer in the morning. it is a tight squeeze in there hope i can get an angle on it to strike not much room for back swing. at least i know it is supposed to come apart there without any special tricks. does the splined hole in the u-joint go all the...

here is a screen shot from the wsm showing an overall diagram of the shuttle shift linkage i am having difficulties with. i have not found any info or directions on how to dissemble or replace the different parts here is what the wsm says about removing the shuttle shift lever #6 i can...

thanks guys, i finally got the beast in out of the weather and started taking it apart step by step following the WSM unfortunately i didnt get far before coming to a problem. i have everything disconnected as described in the WSM for the removal of the "panel frame and steering assembly" as i...

thank you, sorry for not being a little quicker on the responses but the end of season root harvest without the tractor has been hectic to say the least. the work space i have is hard packed and covered with weed barrier cloth. it is the propagation green house. would you still recommend the...

contemplating taking the plunge and spitting her open to find what needs a fix'n i did get a copy of the WSM and have read a fair bit into it and am comfortable making the splits. seams pretty straight forward remove all the stuff in the way and then unbolt the major parts and slide them apart...

yes that does seem to be the case unfortunately thank you for your reply I did manage to find an online manual I was able to purchase and download now I just have to decide do I really want to tackle this job of splitting the tractor or am I just didn't have the boss drop it off at the shop and...

hello all, i have an l3600dt-gst that has suddenly started leaking hydraulic fluid profusely but i am having a hard time finding where it is actually coming from. i was running the loader and as i was going back and forth i noticed dribble lines on the ground and i got off and looked under the...