Recent content by Dgmshop

Hello, I this winter I had a grenade go off inside the transmission of my B7510 (blew up running a snowblower, shear pin went, but still managed to treat the trans like a shear pin…) , and it was a huge job to repair. I had to replace the bearing holder P/N 6C05012110, and the hi/lo PTO speed...

Thanks for the input Wolfman, I’ll check it over tonight, I was hoping that was the case. I’ll post an update after I get it split. I appreciate all the replies.

Hello, Thank you for yor interest. I’m in the middle of a transmission repair, and I’m going to do a filter and oil service at this time. My question regards non-OEM filters, and deviating from the recommended kubota Super UDT fluid . Does anyone subscribe to using non OEM equip? Also are the...

Hello, I was curious to know if anyone could advise me on how to move forward with this repair. Following the manual it appears I would have to separate the clutch/bellhousing from the engine, remove the steering wheel, fuel lines, etc. I’d like to know if it is possible to separate the tractor...

Thanks for the input, it was very helpful. I was 4 bolts from making a discovery. Looks as though the 2nd gearshaft with 13T-18T gears has stripped 3 teeth off the 18T portion of the gear. I have provided an image of the damage, and a screenshot of the diagram in question. I also have provided a...

Hello, New to the forum, thanks everyone for your interest and consideration. I’ll try to be as concise as possible. My PTO gave up last week, no grinding, just no action. With the tractor shut down I manipulated the rear PTO in both high and low, can definitely feel it fetch turning in one...