cody you will have to use some type of blade that is harder than the material you are cutting. That is why I suggest a air die grinder if you can get it to the area. Then the shaft will have to be ground down to get the bearing off with cover its going to be a slow job and dirty but doable. I know ive done a lot of this stuff in the last 40 years. Its going to take patients and trial and error on your end wish you were closer. handy
C
cody
New member 45 From Prince George BC Canada
Profile posts Latest activity Postings About
-
Thank you Sir! -
Loading…
-
Loading…
-
Loading…