Lil Foot
Well-known member
Lifetime Member
Equipment
1979 B7100DT Gear, Nissan Hanix N150-2 Excavator
I have a solid state phase converter that gives me 208v 3 phase that supplies my mill & a grinder.
I would like to wire the grinder with a single 60w, 110v outlet for a work lamp. Seems we did this lots of times (30years ago) in the shop at work, but I can't for the life of me remember how we did it.
The power cord to the grinder is 4 wire; red, blk, wht, grn.
The wires from the grinder are marked L1, L2, L3.
L1 is connected to blk.
L2 is connected to red.
L3 is connected to wht.
Grn is connected machine frame.
Any practical way to pull my 110v from from this wiring?
I don't want that essential smoke that keeps all things electrical running to escape, thereby disabling my equipment.
Thanks.
I would like to wire the grinder with a single 60w, 110v outlet for a work lamp. Seems we did this lots of times (30years ago) in the shop at work, but I can't for the life of me remember how we did it.
The power cord to the grinder is 4 wire; red, blk, wht, grn.
The wires from the grinder are marked L1, L2, L3.
L1 is connected to blk.
L2 is connected to red.
L3 is connected to wht.
Grn is connected machine frame.
Any practical way to pull my 110v from from this wiring?
I don't want that essential smoke that keeps all things electrical running to escape, thereby disabling my equipment.
Thanks.