While installing led work lights today I blew fuse 1, the work light fuse. When I removed the blown fuse from the panel fuse 2 came out also, the meter backup fuse. I replaced it and installed a new work light fuse, then I noticed the key was on. I didn’t think much about it until I started the tractor to put it away. Now it acts like it’s in limp mode, won’t run above idle and the pto won’t engage.
The error is ECU NG, Tractor ECU communication trouble. Can I reset this? Also the PTO light stays on.
This photo was taken with it running.
Thanks.
The error is ECU NG, Tractor ECU communication trouble. Can I reset this? Also the PTO light stays on.
This photo was taken with it running.
Thanks.