Can anyone tell him how to get the 3-pt adjustment control knob off? The parts schematic shows being held on with a "spring pin". I assume this is a spring-loaded detent? I don't see a corresponding hole in the knob where I could use a paper clip to push the detent back in.
I need to take the knob off, so that I can get the cover off, so that I can spray the end of the shaft to be able to get this adjustment un-frozen.
I need to take the knob off, so that I can get the cover off, so that I can spray the end of the shaft to be able to get this adjustment un-frozen.