3pt hitch won’t stay put.

[B3350orbust]

I have a B3350 and just added rear remotes and a hydraulic top link cylinder. That all went well and it works great.
Since the upgrade my 3 pt migrate down unless I manually hold the control lever or set the control lever stop screw. In the past I used the set screw to avoid dropping the three below a certain level, like while running the brush hog. When the lever is 2/3 to all the way Up it holds fine otherwise it seems to vibrate down. I’ve looked for something to tighten up but I don’t see anything nor does the wsm mention anything.
Does anyone have an idea what I could have done?

 

[Dave_eng]

I do not know your tractor but have looked at the parts illustration which shows a friction disk likely to hold the control lever in position.

Dave

 

[B3350orbust]

I do not know your tractor but have looked at the parts illustration which shows a friction disk likely to hold the control lever in position.

View attachment 48405

Dave

Thank you I’ll check it out first thing in the morning, I didn’t think to check a parts diagram. Brilliant.

 

[B3350orbust]

Da

I do not know your tractor but have looked at the parts illustration which shows a friction disk likely to hold the control lever in position.

View attachment 48405

Dave

Dave,
I fixed the problem thanks to your input, I appreciate your time and effort.
Rex

 

[Dave_eng]

Da


Dave,
I fixed the problem thanks to your input, I appreciate your time and effort.
Rex

Thank you for reporting back.

It helps everyone gain knowledge and you have learned that the parts info can be as valuable or even more so than the WSM.

Dave