2005 BX 1800 Hydraulic Filter Screen location

n4k

New member
May 1, 2020
9
0
1
HUEYTOWN
I have read and read, watched videos, and read some more, but none of the pics look like mine. Is this the hydraulic suction screen on my tractor? If yes, do I remove the screw that looks to be a stop screw before attempting to remove? If this isn't it, anyone know WHERE it is? Thanks!



Ugh, so I can't post links or images yet. Okay, it's on the left rear near the axle like all the pics and videos. However, it does not have the 10mm bolt, instead it has a cotter pin and in the bottom of where the filter would be is a screw that almost looks like a wood screw. Anyone familiar with this?
 
Last edited:

Dave_eng

Well-known member
Lifetime Member

Equipment
M7040, Nuffield 465
Oct 6, 2012
5,255
1,060
113
Williamstown Ontario Canada
I have read and read, watched videos, and read some more, but none of the pics look like mine. Is this the hydraulic suction screen on my tractor? If yes, do I remove the screw that looks to be a stop screw before attempting to remove? If this isn't it, anyone know WHERE it is? Thanks!



Ugh, so I can't post links or images yet. Okay, it's on the left rear near the axle like all the pics and videos. However, it does not have the 10mm bolt, instead it has a cotter pin and in the bottom of where the filter would be is a screw that almost looks like a wood screw. Anyone familiar with this?
Check your private messages. I have sent you my email.

If you email me your photos I will post them.

Dave
 

Henro

Well-known member

Equipment
B2910, BX2200, KX41-2V mini Ex.
May 24, 2019
6,121
3,421
113
North of Pittsburgh PA
I have a similar vintage BX2200 that is essentially the same tractor. It has been a while, but I remember the screen flange being held in by a bolt. But mine was bought new by me.

No telling what a previous owner might have done to yours.

Take Dave up on his offer. He is very helpful.
 

stuman

New member

Equipment
BX2200
May 2, 2020
4
0
0
KC, MO, USA
I can't see the photo but the screen has a hex head machined on the end, I think 24mm. It is where the suction hose enters the case on the lower left, behind the left rear wheel.

Sent from my Pixel 2 using Tapatalk
 

n4k

New member
May 1, 2020
9
0
1
HUEYTOWN
Thank you both! I felt like an idiot as I had looked for over an hour, and my husband went down and looked, found it and had it out and cleaned in less than thirty minutes. <facepalm>