B2650 wiring harness for work lights

Fox400

New member

Equipment

B2650HSD, LA534, BH77, RCR1260, RB1660

Jul 25, 2019

25

1

3

"The Thumb", MI

Dec 27, 2019

• #1

I'm working on installing rear work lights on my B2650. I've got the dash off and I don't see any factory hook up for the wires going to the rear of the tractor. Anyone know where the switch hook up is under the dash?

Sent from my XT1635-01 using Tapatalk

 

Fox400

New member

Equipment

B2650HSD, LA534, BH77, RCR1260, RB1660

Jul 25, 2019

25

1

3

"The Thumb", MI

Dec 27, 2019

• #2

Never mind. I called the dealer and there is no factory connector for a switch on the ROPS model tractors.

Sent from my XT1635-01 using Tapatalk

 

D

dirtydeed

Well-known member

Lifetime Member

Equipment

B2650 BH77, U27-4R2, BX23TLBM, box blade, rear blade, flail mower, Stump Grinder

Dec 8, 2017

2,872

3,167

113

Wind Gap, PA

Dec 27, 2019

• #3

I'm installing some myself as well. I'm using this kit...

https://www.amazon.com/gp/product/B071ZPX32N/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1

looks decent, however, the leads are not long enough to reach the ROPS so I'm adding some additional wire inside the ROPS using the hole that's already there..

The Relay and switch look pretty well made.

 

NHSleddog

Well-known member

Lifetime Member

Equipment

B2650

Dec 19, 2019

2,149

1,823

113

Southern, NH

Dec 27, 2019

• #4

The B2650 has a 10AMP circuit that is switched on by the ignition sitting by the right rear fender. Use it as is, or add a relay to it, it is already fused and switched.

I was going to add a relay to mine until I actually measured the LED current. The "advertised" draw would have been over 15 Amps, the actual was under 5 AMPS.

 

Last edited: Dec 27, 2019