Hello all, I am new to this site as a member although I have been reviewing articles for many years. Now I would like to solicit advice for a modification I would like to do to my 1980's vintage B7100 (standard transmission).
I have installed the Kubota dozer blade (KUFD110) on the front. When using the tractor I always have to turn the selector under the seat to transfer from the 3 point hitch to the front plow. I sometimes have the rear plow mounted at the same time. It is pretty tedious. I would like to upgrade the tractor to add a manifold block on the right side near the bell housing. I have seen this on other models.
I bought a manifold block/tubing assembly. It was from a B7100 but I assume it may have been from the HST model.
Has anyone done this conversion? I can't find a hydraulic system schematic for my B7100. The older service manual I have does not show it. I realize I will have to cut/weld the hydraulic tubing to fit it to the tractor.
Would appreciate any advice/photos
Thanks
I have installed the Kubota dozer blade (KUFD110) on the front. When using the tractor I always have to turn the selector under the seat to transfer from the 3 point hitch to the front plow. I sometimes have the rear plow mounted at the same time. It is pretty tedious. I would like to upgrade the tractor to add a manifold block on the right side near the bell housing. I have seen this on other models.
I bought a manifold block/tubing assembly. It was from a B7100 but I assume it may have been from the HST model.
Has anyone done this conversion? I can't find a hydraulic system schematic for my B7100. The older service manual I have does not show it. I realize I will have to cut/weld the hydraulic tubing to fit it to the tractor.
Would appreciate any advice/photos
Thanks