B2400 3 point lift jerking

Dunslandloy

Member

Equipment
B2400HSD, KV-1, Oliver 88, MF35, '65 Gama Goat
Aug 4, 2017
39
2
8
SE OH
Hello all. Saturday I was burning brush and using my rear blade to push debris onto the pile. Everything was rosy. Put the tractor away that night. Sunday I decided to back blade the driveway after a snowstorm and the gremlins showed up. While blading, every time I would lift the blade and stop, the 3 point would start jerking/pulsing up and down. If I lowered the blade, no issues. Super UDT2 in reservoir full. Any ideas on what it could be...and how to go about repairing it? Thanks

1999 Kubota B2400HSD
868 hours
Kubota fluids and filters
 
Last edited:

Dunslandloy

Member

Equipment
B2400HSD, KV-1, Oliver 88, MF35, '65 Gama Goat
Aug 4, 2017
39
2
8
SE OH
How far did you have to lower the 3point before the jerking stopped? Could it be adjusted to raise to high?
If I lower it then stop , the jerking continues. Any position other than resting on the ground this is occurring. Thanks