I was successful splitting the engine at the clutch but for some reason I just can't seem to get the front transmission split from the rear. I pulled eight bolts total from the front/rear spacer but just can't get it to break. The manual does say something about stud nuts. I can't find ANY other nuts/bolts anywhere that look like they need to come out. Does anyone have any experience with these beasts?
My goal is to replace the input shaft (main shaft) front of the trany.
I have the top and bottom bolts in now in case it decides to split but this is it right? So its these five and the other three that are out of the picture on the other side.
My goal is to replace the input shaft (main shaft) front of the trany.
I have the top and bottom bolts in now in case it decides to split but this is it right? So its these five and the other three that are out of the picture on the other side.