ehenry
Active member
Equipment
BX22, FEL, BH, 40" pto tiller, 42" Bushog Squealer, pto hole digger, B7300 w/60"
I wasn't sure where I should have posted this. Mods feel free to move if need be.
The u-joint on the outer shaft of my little Squealer 142 lost a clip holding a bearing cup and the cup came out of the yoke. Before the clipper was shut down the cross beat the inside of the yoke up pretty bad. This is an Italian style #4 series yoke with a roll pin keeping it on the shaft.
I've gotten the roll pin out of the yoke with no problem. Will getting the yoke off the shaft just be a matter of heating the yoke and knocking it off?
I've done a number of u-joints before but never replaced a yoke......
Thanks,
EH
The u-joint on the outer shaft of my little Squealer 142 lost a clip holding a bearing cup and the cup came out of the yoke. Before the clipper was shut down the cross beat the inside of the yoke up pretty bad. This is an Italian style #4 series yoke with a roll pin keeping it on the shaft.
I've gotten the roll pin out of the yoke with no problem. Will getting the yoke off the shaft just be a matter of heating the yoke and knocking it off?
I've done a number of u-joints before but never replaced a yoke......
Thanks,
EH
Last edited:
