Go Back   OrangeTractorTalks - Everything Kubota > Kubota Talk > Service, Repair & Maintenance

Service, Repair & Maintenance Offer your Kubota service advice, repair procedures or maintenance tips. Have a service related question? Post here.

Reply
 
Thread Tools Display Modes
Old 3 Weeks Ago   #1
bsamot69
New Member
 
Join Date: Jul 2018
Location: Grapeland, Texas
Equipment: M9000
Posts: 6
Send a message via AIM to bsamot69
Default Adding hydraulic connect to m6060

We have a newer m6060 that has the hydraulic block on rear for implement connection. We also have a m9000 with 2 of these blocks stacked on top of each other. The units look the same have same dimensions. Is there any reason why we can't take one of the blocks from the 9000 and stack it on the 6060 so we could have another set of hydraulic connectors?
bsamot69 is offline   Reply With Quote
Sponsored Links  
Advertisement
Old 3 Weeks Ago   #2
lugbolt
Journeyman
 
Join Date: Oct 2015
Location: Mid, South, USA
Equipment: G1900-S with RC54-G20
Posts: 1,739
Default Re: Adding hydraulic connect to m6060

call the dealer and ask them if the part numbers are the same. They might be. Or they might not be, and if that ain't, there's no literature to my knowledge that says what the differences are.

The lever kit is for sure different.
lugbolt is offline   Reply With Quote
Old 3 Weeks Ago   #3
CapnDean

2nd Yr. Apprentice
 
Join Date: Feb 2018
Location: Gulfport, MS USA
Equipment: L6060,ZD1211
Posts: 131
Send a message via AIM to CapnDean
Default Re: Adding hydraulic connect to m6060

I have an L6060 with 3 remotes. Two of them are used for Top & Tilt Cylinders on the rear implement. I have plugged into the 3rd for my hydraulic lane cutter on the front. I would like to change the valve from a spring loaded (momentary?) to a "put it where you want it and it stays" as it is I have to use a bungee cord when using the lane cutter.

How would I go about finding out the proper part number for the valve I seek?
__________________
L6060HST ,Farmtrac 545DT, ZD1211

Implements for all occasions
CapnDean is offline   Reply With Quote
Old 3 Weeks Ago   #4
Dave_eng
Journeyman
 
Join Date: Oct 2012
Location: Williamstown Ontario Canada
Equipment: M7040, Nuffield 465
Posts: 1,924
Default Re: Adding hydraulic connect to m6060

The easier route is to install a pressure compensated flow control as the lane cutter is likely getting too much flow and tripping the detent.

I use one for my Samurai Sickle mower which attaches to my FEL bucket.

When you get the flow under control, then the valve will stay in its detent.

The control installs in the supply to the cutter motor and the exhaust just Tee's into the return from the cutter.

Dave
Attached Thumbnails
Click image for larger version

Name:	forum flow control.jpg
Views:	6
Size:	91.8 KB
ID:	44458  
Dave_eng is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 03:56 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.