I was working my tractor a little too hard today and the tie rod pulled right out of the shaft. They must be original as their are no grease nipples on them. They are shot. The one end is M20 by 1 rh thread I think the other end is left hand thread. I can not find a listing anywhere for a left hand thread one for sale. The threads are too bad to see for sure. My plan is to buy two new ends put them in the shaft and braze them in place. The brass should replace the missing threads. If I ever need to get them apart I could but honestly if they wear as well as the first set, they will out last the rest of the unit. Any advice on getting a set of them?
thanks
Bruce
thanks
Bruce