Hello all, question, I swapped rear wheels so they are inside out to help give a little wider foot print, also looks better IMO. Is this ok to do? or will it put too much strain on the rear axle assemblies? Approximately 5in more span.
inside out rims on L225
- Thread starter Jim67
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Yes it's perfectly fine to do that to the rear, the axle can handle it.
But do not widen the front the same way.
