Tie Rod ends

chris989

Member

Equipment
L3450
Oct 5, 2016
33
0
6
boise
Hello All,

I have a L3450 and need of the outer tie rod end. My dealer says 175 ++ for just the end and ~350 for the assmbly (inner and outer)

I can not find the part number for the outer but the whole assembly # is 35080-44640.

I already cut the female coupling off so i can weld in just bout any 25$ moog joint easy enough. My taper is .640-.700 and the moogs are ~.600-700.

any advice where to buy at a reasonable price or where to find the correct taper?

If 200$ is the only option, I guess i will bight the bullet.

Chris
 

SidecarFlip

Banned

Equipment
M9000HDCC3, M9000HD, Kubota GS850 Sidekick
Oct 28, 2018
7,197
546
83
USA
I did on my M this spring, 175 clams for the outer. I thought it was highway robbery myself and I really did after perusing Flea Bay and finding them for much. much less, like 50 a piece. The OEM ends don't have grease fittings either. The ones on Flea Bay do.

Needed a main shift boot and it cost me 29 bucks for a small ribber boot (OEM). Some prices are stupid high some aren't like filters. Bet the boot cost about 10 cents to make.

If you need the inner radial joint (my M has a radial joint inboard), that is 350 clams OEM. Never seen those on Flea Bay but tie rod ends, yes.
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,295
4,853
113
Sandpoint, ID
Need the exact model and serial number as there are several steering setup's on the L3450's. ;)