Kubota b6000 parts for sale. What you see in the pics is what i have left. Engine and most of its components are gone. Have complete trans rear end and front end 4x4. Make a honest offer and it could be your. Parts on ebay are crazy. They want 450 for a empty trans casing or rear end casing.
Kubota b6000 4x4 parts (TX)
- Thread starter Gottafew
- Start date
i still have these parts.
I also have a b6100 hst that i just sold the engine off of . I have almost everything else.
I also have a b6100 hst that i just sold the engine off of . I have almost everything else.
I guess i dont have the bottom of the breather. Looked for it with no luck. Will the breather off the 6100 work for you?
whats your price on that connecting rod? I'm opening up my B6000 this weekend and I know I need one of those at the very least
Do you have the plate that attaches to the bottom of the section that has the steering wheel and gearing on top? Looks like there are 4 bolt holes for attachment. Also, there are 4 empty bolt holes on each side of this section in a rectangular configuration and I'm not sure what these would be for...maybe you know or have parts that fit these?
Finally, is the 3-point hardware available?
If you have any of these please let me know what you would like for them.
Finally, is the 3-point hardware available?
If you have any of these please let me know what you would like for them.
Attachments
kitn the plate is not on mine either. dont remember selling it but its gone...
I only have the top arms for the lift.
Racer i will ship...
I only have the top arms for the lift.
Racer i will ship...
That"s a lot of damage for just hitting a fence. How fast was it going?
Good luck with the sales!
Do you have a hydraulic pump for the 6000. Guess need to know if it is the same aa a B6100 also. Mine is the 4 bolt one.
you asking for the 3pt lift pump? i have them on both tractors but have no way of testing them to make sure they are good
Looking at a kubota b6000 new to club and kubota any advice missing a back fender any one have a rear left fender
Hi, I'm looking at the muffler you have in the picture there, provided there are no holes in it. Also, I'm looking for a front wheel, maybe two. They are size 6-14, with 4 bolt holes. (The rim actually has more holes, but I only need to use the 4 bolt hole pattern). Do you have a price and weight (So I can figure out the shipping cost to 98370). Also, do you have a pay pal account for paying? Thanks, Dan
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Diverdan,
Be mindful as to the dates of posts, that post was almost 2 years ago and the OP hasn't been on since 11-11-12.
Be mindful as to the dates of posts, that post was almost 2 years ago and the OP hasn't been on since 11-11-12.