Anyone done this? If so how did you do it? My thought is to swap out the standard M7060 3pt lift assist cylinders with the cylinders used on the M8560 (if they fit). Additional thoughts on this subject welcomed.
Likely on your 7060, as exists on the 7040, there is already provision to change the geometry of the 3 pt lift. There is a height position and a power position. Accomplished by two different holes for the lift links to connect to the lower 3 pt arms.Anyone done this? If so how did you do it? My thought is to swap out the standard M7060 3pt lift assist cylinders with the cylinders used on the M8560 (if they fit). Additional thoughts on this subject welcomed.
Maybe its time to trade up to the bigger M8560 which is designed for the rated loadsAnyone done this? If so how did you do it? My thought is to swap out the standard M7060 3pt lift assist cylinders with the cylinders used on the M8560 (if they fit). Additional thoughts on this subject welcomed.
You did, I was just trying to provide more detailsCould have sworn I said that in my post #3.