Search results

Been try to find an adustable angle grader blade for my little kubota b6000 - I am guessing that 48" would work. Anyone out there find a reasonably priced grader blade? Thanks!

Thanks all, I believe I figured out the problem - so my my front tire when turned at a sharp angle will start to push off the low pressure line and create a leak which then sucks air. I did push hard into a plle of 3/4 quarter minus rock which put too much force on curling rams (create the...

My little B6000 loader has been working great, but in spite of being properly filled (4 inches below breather with rams fully retracted according to manual) the FEL will blow fluid out the breather when hot which is irritating(kinda burps out fluid randomly. I am using a Universal hydraulic...

Thanks for keeping us safe Wolfman

I did not send any $ as I wanted to check with you all first - sender member reported to Wolfman

they did, my kubota dealer checked - they made units for the ROPS program but no more left

Just got a message from a new as of this morning member directing me to a guy named Scott Bahena who has a ROPS for my B6000 - Sites like ours are getting trolled heavy from opportunists so trying to vet Scott -anyone buy from him? Oh, and wants me to pay via CashApp BTC - bit coin apparently

All good! Removing the excess line and supporting it (no belly) and adding a quart of hydraulic oil made all the difference. I believe the fluid was getting hot and aiding in the line belly with sag from heat, supporting it made a huge difference and I believe when I refilled reservoir...

Thanks, and that was a 10 micron - just added about a quart and a half of fluid so that with both rams all the way in, there is about 4 inches from breather - noise has gone away, and I resupported feed line with different routing which also took out the belly in that line (removed about 7...

No, will be adding one, right now unrestricted, clean fluid and also had sucked out and cleaned the bottom of the reservoir

Thanks Dan, Suction side strainer was removed a few months ago on this new to me tractor because it was old and damaged - hydraulic shop felt it was no big deal to run without strainer temporarily until I installed 20 micron spin on filter setup -fluid is all new. My pump is driven off a pulley...

There was a ROPS program and there was a Kubota ROPS for the 6000 - unfortunately, Kubota has no more, was hoping to find someone who has the factory unit

Yesterday, after loading up my bucket with 5-6 loads of 3/4 minus, I started to get some pump chatter (cavitation?) I noticed that my return line (low pressure) was twisting and reduced a little in diameter due to air/diminished flow (?) More importantly, my return line has some excess and had a...

If so, please message me, thanks

I like the idea of using my tractor's pto for the rare power outage and need the grunt of a diesel for a 15k and up generator -unfortunately my little 6000 does not have enough grunt!

thanks, yep - I think I just figured that out but did notice that gens can produce current in either direction, either way, I lack the HP to get a 12kw to produce

As the title says, has anyone used the pto setup on a B6000 to power a 12kw Generator (PTO style Gen) Thanks!

Yep, I work with a shop and will bring them my little tractor in a few weeks for strengthening - will take some before and afters -

Been cleaning up my b6000 that also has the B219FEL. I see a very clean weld repair on both sides of frame under engine and behind front diff - did these frames have weakness issues when fitted with FEL? I am thinking that PO must have overloaded bucket and perhaps hit a hard bump other and...