Search results

I am setting up a sprayer on the back of my Kubota. It has a Tee Jet sprayer controller to electronically open and close valves from the cab. The power source wire of the controller consists of 3 wires: red, blue, and black. It is 12 Volt. I have been told I can hook it to an accessory...

I need to get some wires pulled into cab of my MX6000. It is wires inside a plastic conduit that is about 1/2" in diameter. I might be able to get them in between the back window and the rubber seal, but that is not ideal. There is an access hole to the cab below the window that is plugged...

To mcmxi: Yes, its number 18 in the schematic. Update: I cleaned the screens and let engine cool down 2 hours. I looked under hood, and coolant level in the overflow reservoir w back down to what I am used to seeing. I cranked the tractor, and the EM light did not come on. I drove the...

I have changed the oil once, at the first recommended time interval. According to my manual, next oil change isn't until 400 hours. I haven't checked air filter lately, probably need to. My mower blades are probably not very sharp... most of the hours on my tractor have been with the...

I have a Kubota MX6000 with about 170 hours on it. Today I was using it to mow about a 10 acre field that was not planted this year and had grown up in weed about 6-7 feet high, and very dense. There was a lot of weed seeds in the air. About half way through, I stopped and cleaned the...

Shortening the top link fixed the problem. Now I am grading with no problems. Thank for help.

Need some help from experienced box blade users. I have connected a Land Pride 72" box blade to my MX6000 for the first time yesterday using Quick Hitch. I am confident that I have the box grade level right to left and front to back. I currently do not have the rippers lowered. When I put my...

My top link currently hooks to tractor in the top hole. Will hooking it to a lower hole allow me to raise the mower higher? I am bad at figuring out the geometry of this kind of stuff.

I have a Kubota MX6000. Is there a way to adjust the 3 point hitch so it lifts higher? When I have rotary mower attached, sometimes I would like to lift it high as I back into brush to cut it. Not sure this makes a difference but I do have a Quck Hitch attached, QH15. Thanks for any help.