Search results

  1. J

    Play in TL421 (B21) front bucket

    Hi all, I have a B21 with a TL421 front loader. It seems that there is a lot more play in the front bucket recently. I can now "wiggle" the bucket front to back. I guess the wiggle is about 1". Are there bushings that need to be replaced that will take care of this? Jim
  2. J

    'Orange' Grease Zerks (Fittings) SAE or Metric

    I had the same problem taking grease in certain fittings. My problem was with the ones at the bucket. I had to fully extend the loader bucket for one set and fully retract for another set of fittings. Hope this helps Jim
  3. J

    B21 Alternator

    My B21 HAS AN ELECTRICAL PROBLEM! The alternator works but does not charge the battery. I replaced the battery and had the alternator checked. I had some of the wires in the wiring harness sizzle and melt where the lights/turns signals plug in and the problem started at this time. Is there...
  4. J

    Replace 1 front Tire

    I just replaced 1 front tire on my B21. I may be replacing one of the rears. I bought the machine used, it had a tube in it (rear) and the tube went. I replaced the valve stem and stuck about 6 tire plugs. The tire has held air about 3 weeks now.
  5. J

    Hydraulic line replacement

    Thanks for the reply. I will post with results when I replace the lines later this week Jim
  6. J

    Hydraulic line replacement

    I have to change out a hydraulic hose on the front bucket of my B21. Do I need to drain the "pressure" out or do I just unbolt the connection and remove? Thanks
  7. J

    B21 Fuel Tank

    I used a set of mechanocal fingers to grap the obstruction
  8. J

    B21 Fuel Tank

    I feel your pain! This past Sunday, I spent 5 hours trying to figure out why my B21's fuel bowl would fill up and then empty. Thus, stalling the machine and it would fill the bowl up again. I removed and checked the fuel solinoid, the fuel pump, the filter bowl each to no prevail. I finally...
  9. J

    Looking for B21 wiring diagram

    My B21 starting smoking under the dash panel and when I removed the panel, the connection between the lights and the wiring harness was singed. A couple of the wire leads on the wiring harness side were corroded through and the copper is showing and not making contacts. The fuse box also had a...
  10. J

    Kubota starts then dies

    I have a B21 and had the same problem. It would barely run and sputter then slowly die. I removed the fuel filter and bypassed it and it still sputtered. The fuel was flowing out but not a whole lot. I thought it had to be in the fuel line and not getting enough fuel to the injectors. I...
  11. J

    B21 Electrical problem

    I bought a used B21 TLB. It runs fine but the hourmeter, lights/flasher/horn, the tach and the fuel gauge do not work. There is an aftermarket hour meter and that works. I checked and replaced all the fuses and still nothing. Is there another fuse behind the dash that may be the problem...