Search results

Front tires all on rims, sorry not rear.

There's slots that spring pin rest in to hold pin .

Spring pin broken not holding it in locked position, if there lube both pins with fluid film is a great choice.

Does the loader arm raise to full height or go halve way up and stop raising? And same with the bucket.

Ok, so following those instructions - NOTHING HAPPENS! Holding down the switches and turning it on, I still end up with the E-20 code. I'm a bit thrown by the WSM instructions not doing anything. Any thoughts on that? The main harness has connections that go to seat switches, peel back plastic...

When the main switch is turned to "ON" or "START" position while holding down the DPF INHIBIT switch (2) and the parked regeneration switch (3) together, the service inspect display is indicated. And then, a target mode is selected, the data input and the fine adjustment, etc. can be done. To...

Start tractor, raise 3 point hitch lever all the way up. Shut tractor off, get off machine and lift 3 point lower arms up.should have 1to2"of freeplay. Meaning manually lift it by hands. Otherwise your hydraulic system is running on the relief valve and stop operating loader controls abit...

Does the pin with a spring still have a locking pin to secure it in place?

Stop storing tools/ trash behind seat. You have a blown T/M Controller 5amp fuse and a wire shorting in harness to seat switches.

Torque wrench is a Torque wrench. A needle style are old school tool. Buy a clicker style good for years.

In most cases go to a dealer order a set of rear tires on rims thru whole goods!!! Save alot $.

Front tire R-4s have cheap tubeless valve stems, have tubes installed and then no issue. Loading not recommended. Weights are available to hang off Front bumper.

Mice like to build nest in air filter housing also.

Change air filter, sucks in exhaust smoke, probably black looking.