Search results

I attached my new Blue Diamond 36" brush cutter to my excavator, and although the unit seems to be operating properly, the arm (stick) does not seem to have enough power to lift the unit while it is running. The boom is better but also slower than without the brush cutter running. Am I doing...

I am installing auxiliary flat-faced hydraulic plug-in lines to the front of my KX033-4 excavator to hook up a brush cutter. The fittings screw into the switchable double port near the bucket end, (also used for the hydraulic thumb.) My questions: 1. Is it good or bad practice to use Teflon...

I want to use my L6060 to pull my single axle dump trailer which is equipped with electric brakes. Any ideas on how to connect the electric brakes (7 pin connector on trailer) to the Kubota?

My KX033 Excavator has the Kubota OEM 24-inch bucket and thumb. The teeth on the bucket and thumb hit each other instead of gripping between the teeth like interlocking fingers. As a result, pulling saplings and similar brush can be frustrating as they slip out in the gap between the edge of...

When I purchased it, I knew it was slow, but I can only get it up to its theoretical top speed of 25mph (40 kmh) if going downhill. I wonder if I get full throttle opening when the accelerator pedal is pushed to the floor. Can someone tell me where the throttle actuator is on the motor and if it...

At 250 hours and after parking the unit I noticed that most of the drive's gear oil had spilled on the floor below the inside area of the track. The front (outside) area of the drive unit (and the oil plugs) was bone dry. No external damage or obvious cause. The mobile Kubota mechanic said...

There is no fender clearance at the rear tires of my L6060, so rear chains are not an option unless I install rear wheel spacers, which I don't want to bother with unless I have no option. Anyone tried front tire chains on R4 tires? My driveway is gravel, and I use a snow pusher bucket on the...

My L6060 manual illustrates a fuel tank drain plug as regular maintenance. Where is it? I can't see it, and how is that a maintenance item? Water removal from the tank? Thanks.