Search results

  1. H

    Can you repair an adjustable sidelink?

    Hello, I've got an adjustable sidelink thats busted. I tried to adjust with the snowblower on it...apparently it was too much weight. When mounted, the handle will not turn. If I take off tractor the bottom spins in circles but the length does not change at all. You think its possible/worth...
  2. H

    L3130 Manual : Extremely hard to shift in and out of 4wd

    Hello everyone, I have an L3130 with the manual transmissions (not shuttle shift). The last few times I've used the tractor I've found it almost impossible to shift in and out of 4wd. I had to give up and then try 15 minutes later...sometimes it worked then, sometimes I waited another 15...
  3. H

    Newbie Questions about clutch and pto

    Hello everyone, I've recently got my first tractor, a L3130. I had a few newbie questions... 1) Its a manual. When I've been shifting, I notice it feels weird to be partially engaged, so I tend to try to avoid it. I bring down the RPMs to make the shift as fast/gentle as possible. Does...
  4. H

    I think I broke this adjuster for the 3 point hitch. Can it be repaired?

    Hello everyone, I have a L3130 which had a snowblower on the 3pt for the winter. I used this device (see attached photo) to correct the tilt. However, when I was doing that I think I put too much weight/torque on it and it stopped moving/locked up. Any suggestions if this is something that...
  5. H

    What valve for 3pt snow blower discharge chute?

    Hello everyone, I have a L3130 with two rear hydraulic ports already installed. I only use if for the backhoe, when it is not connected it just connects to itself (creates a closed loop). I just bought a 3pt (pto driven) snow blower used. Woods sb74. It has a hydraulic rotation motor for the...
  6. H

    Clearances for loader pins?

    Hello everyone, I have a LA723 Front Loader that the prior owner did not treat right. I have to replace the top pivot pins (where the arms attach to the mounting bracket) AND rebuild the hole. I bought the replacement pins ( 7J267-58752 ) and I was planning on welding some DOM (Drawn Over...
  7. H

    Someone modified my cooling system : Kubota L3130

    Hello everyone, I just installed a block heater in my L3130. For some reason, my coolant reservoir does not have a line coming out of the bottom...just an empty nipple. The radiator has two big lines (one on top/one on bottom)...a small line from the radiator cap which goes to the reservoir...
  8. H

    L3130 : Front tire won't release any air

    Hello everyone, I went to check the tire pressure on the front tire of my L3130 and it won't read anything. A screwdrive pushed down the valve doesn't nothing either. I've never had to deal with this. Any pointers? I'm assuming that i have to change the valve core but I'm not sure what...
  9. H

    L3130 : only 4L oil came out of engine

    Hello everyone, I recently purchased a 2004 L3130 4x4 Manual with 2k hours. Im taking care of some odds and ends and drained the engine oil last night. Only 4L came out. Manual says 5.7L capacity. I made sure to do both plugs, tractor is pretty level..not perfect but close. I couldn't warm...
  10. H

    First Tractor (L3130) - Leaking axle seal (front) + beginner questions.

    Hello everyone, Well...after 5 years of saving and over a year of looking I just picked up an early model L3130...literally got it a home less than an hour ago. The guy said it was a 2000...looks like they didn't start making them until 2003 so who knows. 4x4, 8 speed, LA723 Loader, BH90...