Search results

Missed the hydraulic bit, but I guess you could cable tie them, if ya got nothin else

This is what I did, works as expected

If yours is anything like mine, mine reads nothing when I first pull it out, reinsert and pull again, reads normally. Seems the tube air-locks

Had an IH 1ton pickup, all wheel drive, split windshield and 3 piece rear window. Bought it with my dad in 83, was a he'll of a truck and some really good memories around it. Still have dreams of it, and my dad. Happy fathers day to all

Presently present

Here's one I built with my uncle about 20 years ago, it will get it done and it will teach patience. I rent an excavator now and then, but use this thing quite a bit

There should be a knob, between your legs as you sit in the seat that will adjust the flow of fluid leaving the cylinder, therefore adjusting drop speed. Loosen it up

Happy new year, may it be a better year than 2021. Hope y'all have a healthy and prosperous new year

I purchased a landslide box blade in the spring, looked at the TSC, but if I remember correctly, they didn't offer a 52", which is the recommended size for my machine. I'm pleased overall with it, I have used it pretty much and pretty hard as well.

The manifold is a piece of art! Very nice work, I'll be anxiously following.👍

Well done!

The factory option is the sme, just installed one on a 3901. Directions are basically the same as well. When connecting the electric, my personal preference is fused full time power, as you can bleed off pressure from the valve with the key off, momentary switch failing in the on position is...

Try a little dab of grease to hold them in place

I have drilled and tapped 2 of my smaller weights, and use a 1/2" bolt to clamp them to the rack or plow and pinch the other weights

Good for you, best of luck with your new toy!

That's quite the rack, by the way!

Scuffed, primed, and painted. Worked out well

Uhh, move.

Once I get it, I'll update this thread with thoughts and photos. Should have it within 2 weeks, might still be a bit too wet to use, though