Search results

  1. D

    1995 L355SS issues

    I have a fuel leak from the rear injectors return hose at the injector barb. I cant seem to raise thge dash, the shuttel shifter dosent have a way to disconnect from the out side. The dash will only raise an 1". Any way to run a new hose or splice the old? Maybe a better hose clamp? I also hear...
  2. D

    Cleaning engine L355SS

    My engine is pretty greasy grimmie and dusty. I'd like to power wash but don't know if that's a good idea. Thought?
  3. D

    Fuel leak L355SS

    I have a fuel leak coming out of the hose on the left at my rear cylinder. It runs up to the shroud covering the gas tank. Can I pull it off and cut it back and reattached without causing a problem?
  4. D

    L355SS 3-point & box blade

    I tried to use a box blade on my 3-point to level out bumps and ruts on about a ½ acre plot. It doesn’t stay level. As soon as it starts to load up it starts to raise up. How can I get it to stay put?
  5. D

    Hydraulic and transmission oil.

    Any thought about using 20w50 synthetic oil? I use it in my motorcycle, zero turn and Ford F-250. Wondered how it would do all my transmission with 3point 1720 loader. I have a 1995 l 355 SS with loader.
  6. D

    L335SS issues

    My L355SS year about 1995: It is getting extremely hard to shift the PTO to engage. I had to get off the tractor and slam it to get it to engage. Thoughts or Ideas? Other problem, the Draft control lever falls when I use the 3-point. Had to clamp something Infront of it to keep it in place. I...
  7. D

    hydraulic pressure -loader and 3 point

    My loader and 3 point dont have the "oomph" I think it should (L355SS). How can I check its hydraulic pressure?
  8. D

    L355SS sometimes not moving forward.

    Well I've been through all the major transmission problems with this tractor. Had a bad bearing on my clutch pack. That's fixed, in the tractor runs good. But sometimes I think I've always noticed this, I shift into gear and move forward on the shuttle shift and it doesn't move. Then I hit...
  9. D

    Kubota 1720 L355SS-Oil Filter

    What's the right part number? I bought a HH150-32430 an its way to small. I cant see the numbers on my.
  10. D

    L355SS-stpped moving

    I Just got it back from the shop. Started to pull out my flat bed from a muddy pasture with the bucket and it stopped moving. No forward or reverse and the 3 point wont move. It was a little low on hydraulic oil, i added couple gallons and still nothing. Ideas?
  11. D

    Kubota l355SS oil site glass

    kubota l355ss oil site glass ---My popped out and I pematexed it back in. Where can a get a new one?
  12. D

    kubota l355ss oil site glass

    My old tractor, started up and popped the site glass out, spilling maybe 1/2 gallon of fluid. I found it ,cleaned it a little (the inside plastic piece fell apart) . permatexed the seal and popped back in. Where can I get another for when this falls back out?
  13. D

    No ignition L355SS

    After old faithful cane back from the shop, bad bearing on my clutch pack (not cheap) I went to start it on a cold day. The glow plugs heated and it turned and it turned slow, so I hit the glow plugs a gain tried to start at it died all light outs. I charged the battery for a few days on my...
  14. D

    Hydraulic Top Link, Cat 2, 3" x 8"

    Where can I get a cylinder like this? Maybe I need a smaller one? I have a 40y/o L355SS and use a brush hog, spike, and box blade. I will probably add a rake and rent a tiller or disc. Our local hydraulic store wanted $600 to fix and I think I have seen them around $175-$225. Ideas?
  15. D

    L355ss electrical

    How hard would it be to rewire my tractor? Just the major wiring not lights. Electric is not my forte.
  16. D

    No Ignition old L355SS

    Battery was low, glow plugs lights worked but it just clicked when trying to start. I looked at terminals and replaced the positive cable end ( I did hit frame and got small spark) because of corrosion. When it looked to have a good charge I turned ignition key, glow plug lights came on...
  17. D

    L355SS stops moving

    I have an old LS355SS and today when I hooked up the Brush Hog, I was mowing for 5 or so minutes and it just stopped going forward, like it shifted into neutral. I lifted the Brush Hog and it moved again. Then it wouldn't go forward, but did in reverse with the brush hog raised, I was able to...