Search results

The hydraulic oil kept flowing as I tryied to open the bottom of the hydraulic oil filter. I thought I might get a pint, not 4 quarts. What should I di to clean the screen and not get a mess?

Looks like the noise MIGHT be the alternator, going to let it goes until it fails. I went to clean the hydraulic filter, put a bucket under it and cracked the 3 bolts a bit. Tractor was cold. It kept draining and after about 4 quarts I tightened back up. I didn’t see a shut off in the manual...

Thanks, now things make sense. Your exploded view looks like my machine. The PDF’s I bought, don’t quite match.

My parts manual lists 005 as front axel support. Cant find a lash. Also how do you get to the plug on top? Looks kind of buried. Another thought, might the squeaking be from the water pump bearing? (but it only squeaks when driving)

I have 3 PDFs . Owners manual, service manual and parts manual

Ive corrected the fuel line and added 80-90 on both iside of the frone end. Where is the center located and the drive line center suppport?

I have a fuel leak from the rear injectors return hose at the injector barb. I cant seem to raise thge dash, the shuttel shifter dosent have a way to disconnect from the out side. The dash will only raise an 1". Any way to run a new hose or splice the old? Maybe a better hose clamp? I also hear...

Thank you. I will use discretion, I have a lower end electric power wash, I'll try not to blast it.

My engine is pretty greasy grimmie and dusty. I'd like to power wash but don't know if that's a good idea. Thought?

Thanks for the help.

I do. Wish I had a parts manual.

By the way what is the piece under the fuel hose with the wire coming out the top?

Anyway to run that hose to the gas tank? It looks like it's covered up pretty tight.

I have a fuel leak coming out of the hose on the left at my rear cylinder. It runs up to the shroud covering the gas tank. Can I pull it off and cut it back and reattached without causing a problem?

My top link attached to my top cylinder

I wonder if I should take the hooks out? I tend to pick up a lot of twigs and small sticks. I had this area cleared 2 years ago.

I tried to use a box blade on my 3-point to level out bumps and ruts on about a ½ acre plot. It doesn’t stay level. As soon as it starts to load up it starts to raise up. How can I get it to stay put?

I worked at a company that made hydraulic equipment. We prototyped parts and bearings that would give increased longevity to the equipment. We didn't introduce them because we made very good profits on replacement parts. Engineers are paid to recommend methods and parts that increase profits to...

Thanks. Because it's recommended for my hydrostatic transmission, I thought it might have application in the loader.

Any thought about using 20w50 synthetic oil? I use it in my motorcycle, zero turn and Ford F-250. Wondered how it would do all my transmission with 3point 1720 loader. I have a 1995 l 355 SS with loader.