Search results

I wanted to update in case it may help someone else with the same issue. It turned out to be the float detent that needed to be rebuilt. I replaced with detent rebuild kit and new spool housing kit. Thanks to everyone who made suggestions, especially North Idaho Wolfman.

I wanted to update in case it may help someone else with the same issue. It turned out to be the float detent that needed to be rebuilt. I replaced with detent rebuild kit and new spool housing kit. Thanks to everyone who made suggestions, especially North Idaho Wolfman.

Retaining clip at the end of the spool housing was completely deteriorated. I’ll continue taking apart,

Verified the cable is not broken. When disconnected from the valve, the controls work fine and the cable expands/retracts normally. Removed the spool cap and the entire valve came out (I may be referring incorrectly to specific parts). I had purchased a detent rebuild kit, but don’t see any...

I’m still troubleshooting the loss of lift on my LA680/L3600. I have full tilt capability, but no lift/lower. If I swap coupler banks, I lose tilt and gain lift back. The control lever works fine left to right, and seems to go forward, but not back. It stops completely back at the center point...

Thank you. I’ve never been able to float either, so perhaps the coupler is the issue for both.

I swapped the connections and lift returned, lost tilt. I didn't swap hoses, just connected to the tilt pair of couplers. Could I have a bad coupler on the lift side? Again, controller symptoms are the same as when frozen before warming up. With the swap, the lift works immediately (although...

Checked it today. Looks good.

Thanks. I actually rotated through all of the couplers to test the tilt/lift swap. All the couplers seemed to be fine, even though I had everything mixed up in terms of functionality. I never lost an individual function, always the up and down together. When I swapped with tilt, I gained it all...

I doubt it. It does take warming up to get going and that was the case today. After warm up though, it worked fine for 45 minutes or so. I've never had ice build up in the cable while operating, but I suppose anything is possible. The symptoms when it's frozen are the same as now.

I have an L3600 with a front mounted snowblower. After blowing snow for about 45 minutes today, I lost the lift control (up and down). The controller inside the cab seems unable to maneuver for up and down control. I've checked the hydraulics by swapping the lines between the lift and tilt. When...

Hahaha...Nope, just found one and it was delivered today. We might be hit a few more times here in Northern Michigan! Sent from my iPhone using Tapatalk

Looking for instructions or video demonstrating how to connect the mount and front snowblower on an L3600 or something similar. Thanks! Sent from my iPhone using Tapatalk

Awesome. Thanks Wolfman! Sent from my iPhone using Tapatalk

Thanks. That makes it pretty tough then. I found a mount, but do I want to risk not being able to determine what fits on it? Sent from my iPhone using Tapatalk

Looking for a list of compatible front mount snowblowers that will fit a quick hitch mount L2054B...Thanks

Thanks. Do you happen to know what other model number blowers will fit the 2054 mount? Also, any idea are there non-Kubota (aftermarket) options out there for a front blower for the 3600! Thanks for sharing your knowledge. Really appreciate it...

Thanks Wolfman. Have you seen any fabrication attempts to convert another blower for use on a 3600? I found the mount, but not the blower. Appreciate your thoughts! Thx

Thanks Wolfman!