Search results

I have a Rhino Ag TS12 flex wing cutter. When installing the two wing drive lines from the splitter gearbox to the wing gearboxes, does it matter what position the blades are in? Does this have anything to do with possible vibration issues?

I looked in the manual and I have the drawbar in the position that is shown. In fact, it even shows the correct hole to put the pin. I looked at the specs and it appears the drawbar i have is the one for my tractor. I did buy it new and that is the drawbar that was with it. Even if I got a...

Actually, the Rhino TS12 does not use the CV...it uses a regular u-joint which is an advantage since it is much smaller than a CV. That does make sense about the stub shaft length. I will look into that to see if there are any options. The other problem is that the vertical distance between...

The drawbar that came with it is a standard 26.56” bar and I have it in the last hole that will allow the bar to engage the support. I am wondering if Kubota offers a different drawbar mounting bracket that might sit further back?

I have run into another obstacle with my efforts to connect a Rhino TS12 flex wing cutter to my Grand L6060. The tractor drawbar mounting bracket is so far back under the tractor that the drawbar will not extend far enough to get the required 14” from the end of the PTO shaft to the implement...

I looked at this one but have the HP to pull a 12ft cutter. Do you think the TS12 would be too much weight on my tractor?

The drawbar spacing is definitely an issue. Only 5-1/2” between top of drawbar to center of PTO shaft. Would it be acceptable to use a 2” offset drawbar and drop the drawbar height to give enough clearance?

I have a Grand L6060 and looking to purchase a 12ft flex wing cutter. I am considering the Bush-Whacker MD-144 which weighs about 3,300lbs. Will be using it to maintain pastures which are pretty hilly. I have the tires filled with beat juice which brings total weight of my tractor to about...

The maintenance schedule in my Grand L6060 owners manual indicates changing the engine oil and filter at 50 hours which I have done. However the next scheduled engine oil and filter change is not until 400 hours. This seems to be a lot of hours. Is this correct or should I change it sooner?

Is it possible to use an offset drawbar to lower the height of the hitch point? This would increase the vertical distance from the top of the drawbar to the PTO shaft. This would provide more clearance for the driveline which might gain enough space for the Land Pride LP hitch without...

That makes perfect sense. Have you been happy with the cutter? I have been comparing it to the Rhino TS12. The Land Pride has dual leveling rods where the Rhino only has a single rod. I have read a lot about wheels...laminated vs aircraft tires. I don’t anticipate needing to tow it on the...

Looking for advice on Land Pride RC2512 12’ cutter for my Grand L6060. I want to order a new RC2512 with the LP Performance hitch. According to Land Pride, the LP Performance hitch may not be compatible with my Grand L6060 due to the spacing from the draw bar to the PTO shaft. Does anyone...