Search results

I have a LA402 loader that is now loose and rattles the right side is still tight. Is it normal wear or can it be fixed it. It seems that there is play in the upper cylinder housing and the boom also is this something that i can fix or normal

I have Kubota B-7800 and I was wondering what color the Rops are. Is it the same color as the and frame. Is there a part number.

I over loaded my front and a snap the front axle. Has anybody replace the front hub/axle ass. I removed the studs and chase with a die and they seem to be Ok do I need the gsk for the eight bolt cover and It looks like a C clip retains it. What would you recommend for front Gear Oil. Any help...

I purchase rear stabilizer bar links from Mark Hodge and it was the best investment I have made for my Kubota. I just want to give my praise to the quality and service that Mark provided. With the P.A.Ts quick attachments and longer upper link and better stabilizer bars, it makes swapping...

I have B-7800 LA-402 front loader and I cut the handle down about two inch's I like it better. Maybe you would too.

Don't laugh. but they seem to work for me. I have other attachments. But these might interest you. Also, check out these floor mats I purchase them at Costco and they worked for my CJ5 front and the rears work for my B-7800. Because I worked at a GMC dealership there was a lot of discarded truck...

I knew this was a good investment there are so many things you can do with it. Just use your imagination. I it works for me.

I'm starting to have the hoses from the control valve to the pipes running down the loader arm look like they were cut. Just one is showing the inner webbing, and two look good. So I ordered all of the hoses (4). This is the first time I have replaced hydraulic hoses will it self bleed by...

I want to replace my front loader Bucket. Is there anybody out there that you would recommend where to purchase one? It is an LA-4200. I am in California. I do need one with pins. I don't want to give up 150 Pounds for a quick connection and have to weld plates

I want to clean the dust and install L.E.D bulbs. Does the lower panel need to be removed?

Does anybody know of three-point telescoping arms as the B2900 has? That would fit my B-7800. I have the Pats system and longer upper link but it would be nice to have the telescoping arms.

I using an AC 51RPS 85 500cca I think it a group 51 series.

I have a B-7800, and the speed control will not center. If I cycle pedal and it will not return to center it back and forth. I am thinking it the spring on top or damper. How hard is it to remove the floor to inspect the spring? And could I remove the damper a diagnose it(like a Shock )? The...

I was wondering if anybody has replace the Standard headlight with leds. Its a single element and if you knew the part number?

After using a landscape rake I need something that will smooth fine dirt almost like sand. I don't think a landplane or box scraper will work. I need level high spots and where the rake dug-in.

What I found was the headlight bulbs have no power, grounds are good and bulbs are good. The Dash lights and tails work fuse is good. I thinking were the hood opens the it have a break in the wire B+ or a bad headlight switch. How hard is it to get to the headlight switch? Sorry I mean remove...

There is attachment that I use almost every day a Debris rake from Gearmore. It clamps on the lip and is very sturdy.You might think about it. How are the new tractors with the regenerative systems working out?

I have a B-7800 with a LA 402 front loader,at idle the loader handle rattles.They have wave washers is tightening it the only way to stop it. Or has somebody figured out a better way of stopping this.